117
6
ENGINE
FITTING THE CONROD AND CRANKSHAFT
ASSEMBLY
• Fit the conrod and crankshaft assembly into the LH
crankcase.
• Tighten pin P/N 64712 at the end of the crank ass-
embly.
• Fit to casing with tool P/N 64706 fi tted with plate
P/N 758466.
• Centre the assembly to the casing with 4 bolts (1).
• Fit centring tool P/N 64710 to tool P/N 64706.
• Tighten pin nut P/N 69104 on pin P/N 64712 in
order to bring the crankshat assembly into contact with
the bearing ensuring that the crank is pointing towards
the cylinder side.
FITTING THE GEARBOX
• Put the clutch pushrod (1) in the input shaft.
• Install at the same time the input shaft ans secondary
shaft assembly in the LH crankcase.
Summary of Contents for MH7 Naked
Page 1: ......
Page 138: ...Created by www ciandisseny com...
