Motorhispania MH7 Naked, Workshop Manual

Page: 58 / 138

66
5 ELECTRICAL SYSTEM
5
5.5. Automatic Chronometer Function (LAP)
This function describes the correct working/visualization
of the chronometer related to TD and AVE.
This information is visualized by using digit 13÷16
and logo LAP.
The data represents the effective route time of the vehi-
cle in the form mm:ss if hours = 0 (pic.5-8) and in the
form hh:mm if hours > 0 (pic.5-9).
It is automatically activated by the fi rst pulse coming
from the speed sensor and it stops after 3 seconds
from receiving of the last pulse which arrives from the
speed sensor.
If hours >0, when LAP is operative, the digit that
separates the hours from the minutes is shown
blinking, while it is shown fi xed when LAP is not opera-
tive
If hours = 0, when LAP is operative, the digit
(‘ and “) that separates the minutes from the se-
conds is shown blinking, while it is shown fi xed when LAP
is not operative.
The data isn’t memorized in a permanent mode.
It is possible to set to zero the counter of this parame-
ter by pushing the
Set button for about 2 seconds, in
correspondence of the function LAP till when the value
00’00’’appears.
The setting to zero of LAP, which is possible both
when the vehicle is stopped or when the vehicle is
running, produces the setting to zero of TD and AVE too.
If the data gets over the value 23-59 (which means
23h59’59”), the system provides to set to zero LAP, TD
and AVE, then it starts again the counting.
Obs. 5-5: If there is no feeding the LAP value is
hopeless lost.
5.6. Average speed function (AVE)
This function describes the correct working/visualization
of average speed function related to TD and LAP.
The information is visualized by using digit 13÷16 and
logo AVE (pic.5-10).
The data represents the average speed of the vehicle
(expressed in Km/h or in Mph depending on the selec-
ted measurement unit) that is calculated as ratio bet-
ween covered distance (TD) and the time used to cover
this distance (LAP).
The average speed is updated every 0,1 Km (or
0,1 Miles, depending by measurement unit
selected).
Picture 5-8: lap in format mm:ss
Picture 5-9: lap in format hh:mm