31
TriStar MPPT-600V-TR Operator's Manual
E. Connect one or two sets of (+) and (-) solar array wires to the (+) and (-) solar array input
terminal blocks.
WARNING: Risk of Damage
Be very certain that the battery connection is made with correct polarity. Turn on the battery
breaker/disconnect and measure the voltage on the open battery wires BEFORE connecting
to the TS-MPPT-600V-TR. Disconnect the battery breaker/disconnect before wiring to the
controller.
AVERTISSEMENT : Risque d’endommagement
Assurez-vous que la connexion a la batterie est effectuée avec la polarité correcte.
Activez le coupe-circuit/interrupteur de la batterie et mesure la tension sur les câbles
ouverts AVANT la connexion au TS-MPPT-600V-TR. Déconnectez le coupe-circuit/
interrupteur de la batterie avant le câblage sur le contrôleur.
CONNECT WIRES TO (+) AND (-) BATTERY BANK POSTS (not shown).
F. Extend and connect the (+) and (-) battery wires to the (+) and (-) battery terminals on the
battery termination blocks of the TS-MPPT-600V-TR.
G. The TS-MPPT-600V-TR (option without GFPD) is shipped with unconnected
transfer switch solar battery charging wires. As shown in Figure 3-10 on page 28, connect
these (+) and (-) wires to either the controller's (+) and (-) solar terminal lugs, or route through a
GFPD-600V, and then connect the GFPD return wires to the controller's (+) and (-) solar
terminal lugs
.
H. Use copper wire to connect all unit grounding terminal blocks, equipment cases, battery (-) and
any other metallic system components e.g. panel frames, wind turbine, to earth ground. Refer to
Step 10 - Grounding and Ground-Fault Interruption for more information.
