10
Morley-IAS
996-203-000-2, Rev. 02
3.3.2 Installing the Complete Assembly
-
Offer the complete assembly to the recess to check for correct depth and clearance. Repeat this
process until the correct depth and clearance have been achieved.
-
Support the bezel / back box assembly in the desired position in the recess and mark the three fixing
points in the panel (refer to surface mounting installation instructions for positions). Remove the
assembly from the recess.
-
Drill the supporting wall as described in the surface mounting instructions.
-
Remove the required knockouts and install all cable glands as required.
-
Orientate the bezel / back box assembly correctly, offer it to the recess, then feed the cables through
the glands and take up any excess slack. Secure the assembly in position using appropriate-sized
screws as described in the surface mount installation. To avoid distorting the back box, do not over-
tighten the screws.
www.acornfiresecurity.com
www.acornfiresecurity.com
