Moog ISA1 Series, Instruction Manual

Page: 8 / 16

Mounting ISA 1
8 Rev. -, April 2019
4.3.2 Connecting cable to plug connector
Fig. 6 Plug connector

Insert a small screwdriver next to the wire orifice and tilt it downward.

Slide the wire into the orifice.

Pull out the screwdriver. The wire must be firmly clamped in the plug connector.

Repeat the procedure for all the wires.
4.4 Setting the addresses
The addresses are set via the DIP switch
(Fig. 7) in accordance with the following
table. A maximum of four sliding ele-
ments per sliding system can be con-
nected to one sliding system drive.
Fig. 7 DIP switch