MSD Servo Drive AC-AC Operation Manual
moog
47
Id. no.: CA65642-001 Date: 03/2012
[
Commissioning
]
4.4 Integrated control unit and MMC-card
The device internal control unit enables diagnosing the MSD Servo Drive AC-AC.
Moreover, using the MMC-card eases series commissioning without PC. The control unit
consists of the following elements, which are all located on the front of the device:
•
2-digit 7-segment display (D1, D2)
•
two buttons (T1, T2)
•
MMC-Slot (X1)
MMCplus cards of type SC-MMC128 can be used (128 MB memory and 3.3 V
supply voltage, for further details see MSD Servo Drive Ordering Catalog).
Fig. 4.1 Integriated control unit
D1
D2
T2
T1
X1
The following functions or displays are available:
•
Display of device status (see section 5.1.1 from page 53)
The device status is displayed after the control voltage has been switched on. If no
input is made via the keyboard over a period of 60 seconds, the display returns to
the device status display.
•
Display of device error (see section 5.1.2 from page 53)
If a device error occurs the display will immediately change over an display the
error code.
•
Parameter setting (display “PA“) (see section 4.4.3 from page 49)
To reset the device parameterization to factory settings as well as dataset handling
via MMC-card
•
Ethernet IP-address setting (display “IP“) (see section 4.4.4 from page 50)
To set the Ethernet IP-address as well as the subnet maske
•
Field bus settings (display “Fb”) (see section 4.4.5 from page 51)
To set e.g. the field bus address
•
Firmware update with MMC-card (see section 4.4.6 from page 52)
