© MOOG 2010
This document is subject to MOOG INTELLECTUAL AND PROPRIETARY INFORMATION LEGEND . The details are on page II.
66
MRJ04410
2-4-7.
F1+Set: Set Up Mode
Mode is displayed by pushing the F1+SET
Display
Not available when manufacturing containers
Function
Set Up is used to set up the conditions and parameters re-
quired for proper operation when the container and/or die
gap tooling are changed.
Commands
Set Up Mode is covered in detail in the DigiPackⅡInstallation
manual, 1-7. TOOLING SYSTEM SETUP
2-4-8.
F2+Set Analog monitor
Mode is obtained by pressing F2+Set.
Display
Not Available while manufacturing containers
Function
Internal signal assign to analog monitor channels 1 to 4. (TB1,
11, 12, 28 and 29)
Commands
Change the displayed parameter using the Set Key, revise the
value with the Entry Knob and confirm with the Set Key.
Signal
The following signals able to set to “Signal”, then each
channels are monitored on Monitor channel on TB1.
Figure 2-30 F1 + SET: Setup Screen
Figure 2-31 F2 + SET: Analog Monitor Screen
