© MOOG 2010
This document is subject to MOOG INTELLECTUAL AND PROPRIETARY INFORMATION LEGEND . The details are on page II.
38
MRJ04410
1-7-7.
GAIN SETUP
Use the Cursor to move to Gain. “
Figure 1-40
” and press
SET. Gain controls the quickness and stability of the Die
Gap Tooling Actuator. At this time the hydraulic pressure
should be increased to its proper value.
Use the Cursor to move down to MOVE… Twist the
ENTRY Knob back and forth and observe the DCDT / SSI
voltage indicator. It should move back and forth, following
the ENTRY Knob motion faithfully. If it seems sluggish,
move back to the gain setting and increase Gain by 25%
followed by Set. If it seems to be noisy, move to Gain, and
decrease it by 25%, followed by Set. Continue until the
response seems to be good and then move with the Cursor
to Back and Set.
If an oscilloscope is available, connect the Y axis to TB-1,
19. Ground to TB-1, 21. Set the sweep to 0.5 sec/division
and return to MOVE. Adjust the response to ENTRY knob
motions until a damped response is obtained. Finish with
Back and Set. This completes the SET Up for Continuous
blow machines.
A NOTE REGARDING CORE STROKE AND ZERO
The DigiPackⅡfeatures the ability to store the program
information for individual containers as shown using a spe-
cific tooling head and mold. This is done to enable the cus-
tomer to readily change between products with the expec-
tation of a minimum change over time from the stop of
production to the start of production of the new container.
Figure 1-41 Die Gap System Gain Setting
Figure 1-40 Gain
