3.1.6 COPY SCANNER
To save time, you can copy the settings from one Scanner to that of another. In
this example, we will review how to copy Scanner 1 to Scanner 2.
1. Press and hold the SCANNER 1 button.
2. While holding the SCANNER 1 button, press and hold the SCANNER2 button.
3. While holding the SCANNER 2 button down, release the SCANNER 1 button.
4. Release the SCANNER 2 button. All SCANNER LED indicators will flash to
confirm the successful copy.
3.1.7 REVERSE CHANNEL OUTPUT
You can permanently reverse the output of any given channel on the controller.
1. Press and hold the PROGRAM button until the LED blinks.
2. Simultaneously press the FINE and MODE buttons to access the channel
assignment mode, then press the SCANNER button.
Note: Simultaneously press the
AUTO/DEL
and
MODE
buttons to
delete
the reverse channel.
3. Use the BANK UP and BANK DOWN buttons to select pan/tilt.
4. Press the TAP/DISPLAY button to switch between pages.
5
.
Press and hold MODE button, then press the SCENES buttons to select the
DMX channel. All LEDs will blink.
6
.
Simultaneously press and hold the FINE and MODE buttons, release them, then
press them again a second time to exit
3.1.8 FADE TIME ASSIGN
You can choose whether the board's fade time during scene execution is
implemented globally, to all output channels, or only to the Pan & Tilt movement
channels. This is relevant because often you will want gobos and colors to change
quickly, while not affecting the movement of the light.
1. Turn OFF the controller.
10
2. Simultaneously hold the MODE and TAP/DISPLAY buttons.
3. While still holding the buttons, turn the controller ON.
4. Press the TAP/DISPLAY button to toggle between the two modes. You can
select either ALL CH, which applies to all channels, or ONLY X/Y, which
applies to pan & tilt only.
5. Press and hold the MODE button then press the TAP/DISPLAY button to save
the settings. All LEDs will blink to confirm.
Summary of Contents for 612120
Page 1: ......