Mondolfo Ferro AS 924, Operator'S Manual

Page: 111 / 332

AS 924 - AS 924 A Operator's Manual 111
UK
- Connect the Doyfe connector on the air hose
to the valve stem (Fig. 33).
- Inflate the tyre with the designated gun or
pressing the pedal in the intermediate position
(Fig. 39), frequently checking that the pressure
indicated NEVER exceeds the maximum pressure
indicated by the tyre manufacturer.
- Disconnect the inflation hose from the valve
stem.
- Press the pedal to bring the column to the "resting" position.
- Remove the wheel from the tyre changer.
8.8.c. SPECIAL PROCEDURE (TI VERSION)
The TI version uses a powerful blast of air from nozzles near the clamping grippers to
facilitate bead breaking and inflation with tubeless tyres.
Before starting with the operations described below, make sure there is no dirt, dust
or other impurities near the inflation nozzles. It is recommended that protective glasses
are worn.
CAUTION
-Check that both the upper and lower beads and the rim bead seat have been suitably
lubricated with approved paste for mounting.
- Bring the horizontal arm to the centre of the wheel (fully extracted towards the operator)
- Ensure that the wheel is clamped onto
the turntable from the inner side (fig. 34).
- Lower the vertical arm to touch the rim
(fig. 35), then lock the arm in this position
34
33
35