Moeller S40-AM-TD, Manual

Page: 52 / 85

Parameter function block
49
02/02 AWB27-1300-GB
Time_clock_adjust 0 to 59 Time correction value in seconds for sychronising the
PLC time.
The value of the time received is added. It must be
calculated depending on the baud rate and the signal
runtime.
Time_dial_timeout 0 to 255 s Local monitoring time during the communication with
the data module.
Time_dtr_break 0 to 255 s The DTR control line is set to 0 for this time in order to
clear the connection.
Time_cut_line 0 to 255 s Maximum bus idle time.
If there is no data traffic for the specified time, the
connection is cleared once this time has elapsed. This
function is deactivated if no parameter is defined.
Time_wait_repeat 0 to 255 s Wait time between dial repeats.
After each abortive attempt, the time is doubled, the
maximum length of time being, however, 60 minutes.
The maximum time is set at “Time_dial_wait_max”.
After a successful attempt, the time is reset to the
specified value. The minimum wait time must be
30 seconds (national value).
This function is deactivated if no parameter is defined.
If “alarm” = 1, dialling attempts are then continued
with the “wait_time” reached by that time.
Time_system 0 to 255 s System time for calculating the dynamic protocol
monitoring time:
From request to response
Time_dial_wait _max 0 to 255 min Max. wait time between the dial repeats
(
a “Time_wait_repeat”)
Parameter Value range Description