modbar Pour-Over, Manual, Page: 22 / 58

EN
22
Touch Save & Exit and then Go to step 16 .
5.5. To program the Profile settings, touch
Brew Settings and the following screen
will appear:
5.6. To set the dispense time for this profile
touch the time next to Cycle time.
The time will be highlighted in red and
can be adjusted using the joystick (+/- 10
seconds) and the rotary encoder (+/- 1
second). Press the center of the joystick
to set.
5.7. To set the total dispensed volume, touch
the number next to Total Volume. Rotate the
encoder to increase or decrease in 1 ml/oz
increments, push the joystick up or down
to change in 0.1 ml/oz increments and left
or right to change in 10 ml/oz increments.
5.8. It is possible to set a pre-wet volume.
This is expressed as a percentage of the
total volume. Touch the number next to
Prewet Percent. Rotate the encoder to
increase or decrease in 1% increments,
push the joystick up or down to change in
0.1% increments and left or right to change
in 10% increments. Press the centre of the
joystick to set. The calculated volume of the
pre-wet will be displayed.
5.9. To set the delay time between the pre-
wet and the rest of the water dispense,
touch the numbers next to Prewet delay.
Rotate the encoder to increase or decrease
in 1 second increments, push the joystick
up or down to change in 0.1 second
increments and left or right to change in
10 second increments. Press the centre of
the joystick to set.