Mobatime 122031, Mounting And Instruction Manual

Page: 90 / 124

© MOBATIME 90 / 124 801214.10
9.2 Device configuration with SNMP
If one or several variables are set in a configuration group with Put , the variable
dts4160????ConfigCmd must be set at the end to 1 in the corresponding group. The
values of the entire configuration group are assumed from the DTS with this command
(1=Save).
As long as the accept command has not been set, the changed variables can be
restored to the old values by setting the
dts4160????ConfigCmd variable to 2 (2=undo,
restore).
After sending the accept command, a dts4160ConfigChanged Notification is sent.
The definitions of the available variables can be taken from the MIB files.
Example:
Management-System DTS
Put dts4160FTPMode=1

Variable is set to 1 internally
Put dts4160NetServicesConfigCmd=1

Configuration group is assumed

Sends dts4160ConfigChanged Notification
with the new time
dts4160NetConfigChangedTime
9.3 DTS subagent SNMP notification
Protocol: SNMPv2c Notification
For Notifications to be sent out, SNMP must be switched on. In addition, at least one
receiver system must be configured.
9.3.1 Startup [dts4160StartUp]
Sent out when the subagent for the DTS is started.
This Notification is always sent out, as soon as SNMP is activated and a destination
address is configured.
9.3.2 Shutdown [dts4160Shutdown]
Sent out when the subagent for the DTS is stopped.
This Notification is always sent out, as soon as SNMP is activated and a destination
address is configured.