Mobatime 122031, Mounting And Instruction Manual, Page: 102 / 124

© MOBATIME 102 / 124 801214.10
Requirements for general active antennas
Frequencies GPS L1, GLONASS L1
Impedance 50 Ohms
Amplifier gain The active antenna must amplify the signal to
compensate the signal loss in RF cable and lightning
protection.
E.g. Antenna is connected with two cables and the
lightning protection.
Cable A 10 m RG 58 C/U
Cable B 10 m RG 58 C/U
Total attenuation 19.2 dB
(referring to the table on
the previous page)
Minimal amplifier gain 19.2 dB
Maximum noise figure 1.5 dB
Polarization Right hand circular
Operating DC voltage 5V
Max. current 100mA (with inserted inline amplifier 85mA)
A.4 Plug-in spring terminals
M
ultiple contact strip 100% protected against wrong plug;
WAGO CAGE CLAMP®-connection
Cross section of 0,08 mm² to 1,5 mm² (from AWG 28 to AWG 14)
Voltage CSA 300 V / current CSA 10 A
Rated voltage: EN 250 V
Rated surge voltage: 2,5 kV
Nominal current: 10 A
Strip length: 7 mm (0,28 in)
Pulled off spring terminal with operation tool:
2 operation tools are delivered with the accessory bag.