Mitsubishi 2015 OUTLANDER, Owner'S Manual

Page: 133 / 490

NOTE
l You can adjust to 8 different levels respec-
tively for when the position lamps are illu-
minated and when they are not.
Each time you reduce two brightness levels,
the segment display of the brightness level
decreases one by one.
l If the vehicle is equipped with the automatic
lamp control, when the lamp switch is in a
position other than the “OFF” position, the
meter illumination switches automatically to
the adjusted brightness, depending on the
brightness outside the vehicle.
l The brightness level of the instruments is
stored when the ignition switch is turned off
or the operation mode is put in OFF.
Driving range display
E00538000014
This displays the approximate driving range
(how many more kilometres or miles you can
drive). When the driving range falls below
approximately 50 km (30 miles), “---” is dis-
played.
NOTE
l The driving range is determined based on
the fuel consumption data. This may vary
depending on the driving conditions and
habits. Treat the distance displayed as just a
rough guideline.
NOTE
l When you refuel, the driving range display
is updated.
However, if you only add a small amount of
fuel, the correct value will not be displayed.
Fill with a full tank whenever possible.
l On rare occasions, the value displayed for
the driving range may change if you are
parked on an extremely steep incline. This is
due to the movement of fuel in the tank and
does not indicate a malfunction.
l The display setting can be changed to the
preferred units (km or miles).
Refer to “Changing the function settings” on
page 5-26.
Average fuel consumption dis-
play
E00531200033
This displays the average fuel consumption
from the last reset to the present time.
The reset mode conditions for the average
fuel consumption display can be switched be-
tween “Auto reset” and “Manual reset”.
For information on how to change the aver-
age fuel consumption display setting, refer to
“Changing the function settings” on page
5-26.
NOTE
l The average fuel consumption display can
be reset separately for the auto reset mode
and for the manual reset mode.
l “---” is displayed when the average fuel con-
sumption cannot be measured.
l The initial (default) setting is “Auto reset
mode”.
l The average fuel consumption depends on
the driving condition (road condition, driv-
ing behavior, etc.). The displayed fuel con-
sumption may vary from the actual fuel con-
sumption. Treat the fuel consumption dis-
played as just a rough guideline.
l The memory of the auto reset mode or man-
ual reset mode for the average fuel con-
sumption display is erased if the battery is
disconnected.
l The display setting can be changed to the
preferred units {km/L, L/100 km, mpg}.
Refer to “Changing the function settings” on
page 5-26.
AS&G monitor*
E00531100029
The accumulated time the engine has been
stopped by Auto Stop & Go (AS&G) system
is displayed.
Refer to “Auto Stop & Go (AS&G) system”
on page 6-28.
Multi information display - Type 2
5-23
OGFE16E1
Instruments and controls
5