Mitsubishi MOTORS Shogun 2007, Owner'S Manual

Page: 428 / 538

6-24
For emergencies
6
5. Move the jack handle up and down to raise the ram until
just before the jack contacts the jacking point of the vehi-
cle. Ensure that the jack will properly contact the vehicle
jacking point.
NOTE
● This jack is a 3 stage expansion type.
6. Raise the vehicle until the tyre is slightly off the ground.
7. Remove the wheel nuts with the wheel nut wrench, then
take the wheel off.
8. Clean out any mud, etc. on the hub surface (F), hub bolts
(G) or in the installation holes (H) in the wheel, and then
mount the spare wheel.
WARNING
!
●
Stop jacking up the vehicle as soon as the tyre is
raised off the ground. It is dangerous to raise the
vehicle any higher.
●
Do not get under your vehicle while using the jack.
●
Do not bump the raised vehicle or leave it sitting on
the jack for a long time. Both are very dangerous.
●
Do not use a jack except the one that came with your
vehicle.
● The jack should not be used for any purpose other
than to change a tyre.
●
No one should be in your vehicle when using the
jack.
●
Do not start or run the engine while your vehicle is
on the jack.
● Do not turn the raised wheel. The tyres still on the
ground could turn and make your vehicle fall off the
jack.
CAUTION
!
●
Handle the wheel carefully when changing the tyre,
to avoid scratching the wheel surface.
BK-BK2008E1ENUK.en-uk-Section9.fm Page 24 Wednesday, January 9, 2008 4:46 PM