Mitsubishi MOTORS LANCER EVOLUTION 2014, Manual

Page: 92 / 338

Free-hand Advanced Security Transmitter (F.A.S.T.-key) (if so equipped)
Features and controls 5-31
5
1. Turn the ignition switch to the “LOCK”
position. If you started the engine with the
key, remove the key from the ignition
switch.
2. Open the driver’s door and turn the com-
bination headlights and dimmer switch to
the “OFF” position.
3. Press the LOCK button (1) for 4 to 10 sec-
onds and press the UNLOCK button (2)
during this time.
4. Release in sequence the LOCK and
UNLOCK buttons within 10 seconds of
pressing the LOCK button in step 3.
N00544700044
If you are near your vehicle and feel threat-
ened, you can activate the alarm to call atten-
tion as follows:
1. Press the PANIC button (4) for more than
1 second.
2. The headlights will blink on and off and
the horn will sound intermittently for
about 3 minutes.
3. To turn off the alarm, press any button on
the remote control transmitter.
N00561300032
Only a F.A.S.T.-key, which has been pro-
grammed into the vehicle’s electronics, can
lock and unlock all the doors, and start the
engine.
If you lose the F.A.S.T.-key, you can order a
F.A.S.T.-key from an authorized Mitsubishi
Motors dealer by referring to the key number.
To prevent vehicle theft, the ID codes for all
the F.A.S.T.-keys except the one for the lost
F.A.S.T.-key must be programmed again.
Take your vehicle and all the remaining
F.A.S.T.-keys to your authorized Mitsubishi
Motors dealer to have your ID codes pro-
grammed again.
N00561400033
To add a F.A.S.T.-key, you must already have
two registered F.A.S.T.-keys.
Registering the ID code can be done by an
authorized Mitsubishi Motors dealer. Or it
can be done by yourself (except for vehicles
sold in Canada). For you to register the ID
code yourself, follow the “Customer
F.A.S.T.-key programming” procedure below.
If you choose to have an authorized Mitsubi-
shi Motors dealer register the ID code, take
your vehicle and all remaining F.A.S.T.-keys
to an authorized Mitsubishi Motors dealer.
N00561501129
You can program new F.A.S.T.-keys to the
system if you have two valid (already regis-
tered) F.A.S.T.-keys, blank (not registered)
F.A.S.T.-key and emergency key (specially
cut for your vehicle at your Mitsubishi
Motors dealer).
To use the new F.A.S.T.-key, it is necessary to
register the key with both the electronic
immobilizer and keyless entry system. Also
refer to “Electronic immobilizer: Customer
F.A.S.T.-key programming” on page 5-27.
For F.A.S.T.-key programming, follow the
procedures below.
1. Remove the emergency key from the
F.A.S.T.-key. Refer to “Emergency key”
on page 5-21.
Using the panic alarm
Replacement F.A.S.T.-keys
Additional F.A.S.T.-keys
NOTE
 You are provided with two F.A.S.T.-keys, but
you may register up to four F.A.S.T.-keys.
Customer F.A.S.T.-key program-
ming (Except for vehicles sold in
Canada)
BK0200800US.book 31 ページ ２０１３年２月１４日 木曜日 午後２時２８分