Mitsubishi Heavy Industries HMK60, Installation Manual

Page: 51 / 288

49
Electrical installation
Relay output for emergency mode
NOTE
Mark up any junction boxes with warnings for
external voltage.
When the switch (SF1) is in " " mode (emergency mode) the
circulation pump is activated (EB101-GP12).
CAUTION
No hot water is produced when emergency
mode is activated.
The emergency mode relay can be used to activate external
additional heat. Between the port 2 and 4 is closed during
emergency mode. An external thermostat must be connected to
the control circuit (port 4) to control the temperature. Ensure
that the heating medium circulates through the external
additional heating.
E P 2 3 4
SMO
Externt
X1
External
RC-HY 20/40
RC-HY20/40 X1
If the relay is to be used for control voltage, bridge the supply
from terminal block X1:1 to X1:2 and connect neutral and
control voltage from the external additional heat to X1:0 (N)
and X1:4 (L).
1 0 E P 2 3 4
SMO
Externt
N L
X1
External
RC-HY 20/40
RC-HY20/40 X1
<Connection example with HMK60>
Connect the port 2, 4, 6 on X2 terminal on AA7 board on RC-
HY20/40 to the port K1, K2, K3 on X2 terminal on HMK60
respectively.
SMO
6
1 0 PE
HMK60
RC-HY 20/40
RC-HY 20/40
AA7-X2 X1
L N 1 1 0 2 3 4 PE
1 2 3 4
LEK
1 2 3 4
X1
1 1 N L 0 E P 2 3 4
-X2
1
12
34
56
2 3 4 5 6
-X1
AA7-X2
X2
X2 X1
M
ERGENCY RC - HY RC - HY F
K1 K2 K3 K1 K2 K3