Mitsubishi Electric QD75MH1, User Manual

Page: 718 / 834

15 - 29
MELSEC-Q
15 TROUBLESHOOTING
Related buffer memory
address
Axis 1 Axis 2 Axis 3 Axis 4
Set range
(Setting with PLC program)
Remedy
34 184 334 484 0, 2
Speed-position switching control (ABS mode) should
satisfy the conditions 1) to 3) given on the left. When
speed-position switching control (ABS mode) is not
used, set 0 to speed-position function selection and
turn the PLC READY signal [Y0] from OFF to ON.
32 182 332 482 0, 1
35 0, 1
After setting the value inside the setting range, turn the
PLC READY signal [Y0] from OFF to ON.
36
37 186
187 336
337 486
487
1 to 8388608
38
39 188
189 338
339 488
489
1 to 8388608
40
41 190
191 340
341 490
491
1 to 8388608
42
43 192
193 342
343 492
493
1 to 8388608
After setting the value inside the setting range, turn the
PLC READY signal [Y0] from OFF to ON.
44
45 194
195 344
345 494
495
1 to 8388608
46
47 196
197 346
347 496
497
1 to 8388608
After setting the value inside the setting range, turn the
PLC READY signal [Y0] from OFF to ON.
48
49 198
199 348
349 498
499
<JOG speed limit value>
1 to 50000000 [PLS/s]
1 to 2000000000 [mm/min or others]
• After setting the value inside the setting range, turn
the PLC READY signal [Y0] from OFF to ON.
• Change the setting into the speed limit value or
below.
50 200 350 500 0, 1, 2, 3
51 201 351 501 0, 1, 2, 3
52 202 352 502 0, 1
After setting the value inside the setting range, turn the
PLC READY signal [Y0] from OFF to ON.