Mitsubishi Electric PUZ-ZM60VHA2, Service Manual

Page: 123 / 140

123
OCH771
<PAR-SL97A-E>
●
●
●
●
●
●
ON/OFF button
Fan Speed button (Changes fan speed)
Test Run button
Remote controller display
Airflow button (Changes up/down airflow direction)
Louver button (Changes left/right airflow direction)
Temperature setting buttons
Mode button (Changes operation mode)
Set Time button (Sets the time)
Timer Off button
Timer On button
Transmission area
Transmission indicator
Timer indicator
Operation areas
Hour button
Minute button
Reset button
Check button
When using the wireless remote controller, point it towards the receiver on the indoor unit.
If the remote controller is operated within approximately two minutes after power is supplied to the indoor unit,
the indoor unit may beep twice as the unit is performing the initial automatic check.
The indoor unit beeps to confirm that the signal transmitted from the remote controller has been received.
Signals can be received up to approximately 7 meters in a direct line from the indoor unit in an area 45 to the left and right of the unit.
However, illumination such as fluorescent lights and strong light can affect the ability of the indoor unit to receive signals.
If the operation lamp near the receiver on the indoor unit is blinking, the unit needs to be inspected. Consult your dealer for service.
Handle the remote controller carefully! Do not drop the remote controller or subject it to strong shocks.
In addition, do not get the remote controller wet or leave it in a location with high humidity.
To avoid misplacing the remote controller, install the holder included with the remote controller on a wall
and be sure to always place the remote controller in the holder after use.
*For explanation purposes, all of the items
that appear in the display are shown.
*All items are displayed when the Reset
button is pressed.
Controller interface