149
OPERATING PROCEDURE
PHOTOS
3. Removing the electrical box
(1) Remove the front panel. (Refer to 1)
(2) Remove the electrical cover.
(3) Disconnect the connector of the indoor coil thermistor.
(4) Disconnect the motor connector (CN211) and the vane
motor connector (CN151) on the electronic control P.C.
board.
(5) Remove the screw fixing the electrical box, remove the
electrical box.
4. Removing the vane motor
(1) Remove the front panel.
(2) Remove the screws (both upper and lower) of the vane
motor, disconnect the connector.
(3) Remove the vane motor.
Photo 4
Photo 5
Drain hose
Vane motor
screws
Vane motor
Fan motor
screws
Indoor coil
thermistor
5. Removing the line flow fan and the indoor fan motor
(1) Remove the front panel. (Refer to 1)
(2) Remove the electrical box.
(3) Pull out the drain hose from the nozzle assembly, remove
the nozzle assembly.
(4) Remove the screws fixing the fan motor.
(5) Remove the screws fixing the left side of the heat
exchanger.
(6) Lifting the left side of the heat exchanger.
(7) Remove the hexagon socket set screws.
(8) Remove the fan motor, and remove the line flow fan.
Electrical box
screw
Photo 3
The screws
fixing the
left side of
the heat
exchanger