5 SIGNALS AND WIRING
5.3 Connectors and pin assignments
47
5
Inserting wire
Insert one wire per wire insertion hole (round hole) of CN25.
1.
Insert a screwdriver diagonally into the operation slot (square hole).
2.
Insert the screwdriver fully while adjusting the angle to the upright position. If performed correctly, the screwdriver will
hold this position even when released.
3.
Insert the properly exposed wire into the wire insertion hole. When doing so, run the wire along the edge of the round
hole to insert it smoothly.
4.
Insert the wire until it touches the back of the hole, and remove the screwdriver while holding the wire.
5.
To confirm, pull the wire lightly. Do not pull harder than necessary. In addition, confirm that the core wires do not fray and
stick out. The wire can be removed by inserting a screwdriver into the operation slot.
