66
NOTE
• When the 32-bit parameter setting or monitor description are read and the read value exceeds HFFFF, the reply data
will be HFFFF.
Second parameter changing
Read
H6C
Read or write of bias and gain parameters (instruction codes H5E to H61 and HDE to
HE1 with the link parameter extended setting = "1", H11 to H23 and H91 to HA3 with the
link parameter extended setting = "9").
H00: Frequency
H01: Analog value set in parameters
H02: Analog value input from the terminal
Write
HEC
When "100" is set in
Pr.52 Operation panel main monitor selection
, set frequency is monitored during a stop and output frequency
is monitored during running.
When position control is selected for the FR-A800 series, the number of pulses is monitored when
Pr.430
≠
"9999".
Displayed increments differ according to the combination of
Pr.37, Pr.144, and Pr.811
. (
Pr.811
is only available for the FR-A800
series.) For the details, refer to the Instruction Manual (Detailed) of the inverter.
Write data is in hexadecimal, and only two digits are valid. (The upper two digits are ignored.)
Differs according to capacities.
Setting from remote registers (RWw0) can be made.
Turning OFF the power supply while clearing parameters with H5A5A or H55AA sets back the communication parameter settings back
to the initial values.
Reading or writing is available when the link parameter extended setting = "1 or 9".
Gain frequencies can be written using
Pr. 125
(instruction code H99) and
Pr. 126
(instruction code H9A) also.
Item
Read/
write
Code
number
Description