6. Troubleshooting
6.2 Checklist (ISA NC Card)
76
6.2 Checklist (ISA NC Card)
If a problem occurs during setup, check the items below.
<Items to be checked after the personal computer is
turned off>
Refer to:
!
CAUTION
Be sure to turn off the personal computer before
confirming the items below.
1. Check that all the cables are correctly connected.
4.3 Setting Up NC Card and Device
Driver (ISA NC Card)
2. Check that the mounted NC Card is securely inserted into the
PCI bus slot.
4.3 Setting Up NC Card and Device
Driver (ISA NC Card)
3. Check that the rotary switches on NC Card (DPADR,
IOPADR, and IRQ) are set up properly.
4.3 Setting Up NC Card and Device
Driver (ISA NC Card)
<Items to be checked after the personal computer is
turned on>
Refer to:
1. Check that NC System Device Driver has been
installed.
4.3 Setting Up NC Card and Device
Driver (ISA NC Card)
2. Check that Runtime Library has been installed.
4.4 Setting Up Runtime Library
3. Check that an NC Card number has been set properly.
4.4.3 Assigning an NC Card No. of
ISA NC Card
4. Check that the utility and MELDASMAGIC Monitor have
been installed.
4.5.1 Installing the UtilityInstalling
MELDASMAGIC Monitor
5. Check that the memory address and IO port address
set on the rotary switch of NC Card is the same as
those selected on the way to installation.
4.3 Setting Up NC Card and Device
Driver (ISA NC Card)
If the problem is not fixed even after carrying out these steps, try operations again after turning on the
personal computer again. If the problem still remains, refer to chapter 6.3 “Troubleshooting.”
Downloaded from
