6. Troubleshooting
6.1 Checklist (PCI NC Card)
75
6. Troubleshooting
6.1 Checklist (PCI NC Card)
If a problem occurs during setup, check the items below.
<Items to be checked after the personal computer is turned
off>
Refer to:
!
CAUTION
Be sure to turn off the personal computer before
confirming the items below.
1. Check that all cables are correctly connected.
4.2 Setting Up NC Card and Device
Driver (PCI NC Card)
2. Check that the mounted NC Card is securely inserted into the
PCI bus slot.
4.2 Setting Up NC Card and Device
Driver (PCI NC Card)
3. Check that the rotary switch on NC Card (CDNO) is set
up properly.
4.2 Setting Up NC Card and Device
Driver (PCI NC Card)
<Items to be checked after the personal computer is
turned on>
Refer to:
1. Check that NC System Device Driver has been
installed.
4.2 Setting Up NC Card and Device
Driver (PCI NC Card)
2. Check that Runtime Library has been installed.
4.4 Setting Up Runtime Library
3. Check that an NC Card number has been set properly.
4.4.2 Assigning an NC Card No. of
PCI NC Card
4. Check that the utility and MELDASMAGIC Monitor have
been installed.
4.5.1 Installing the Utility
4.6.1 Installing MELDASMAGIC
Monitor
5. Check that the station number of the PCI NC Card set
on the rotary switch of NC Card is not duplicated with
that of other PCI NC Card.
4.2 Setting Up NC Card and Device
Driver (PCI NC Card)
If the problem is not fixed even after carrying out these steps, try operations again after turning on the
personal computer again. If the problem still remains, refer to chapter 6.3 “Troubleshooting.”
Downloaded from
