![background image](http://html1.mh-extra.com/html/mitox/26mt-sp/26mt-sp_operators-manual_1807939009.webp)
26MT-SP Multi-Tool
9
Original Instructions Version June 16
Before Operating the Multi-Tool
Before beginning work, carefully check the work area and remove any obstacles. Within a
perimeter of 15 metres of the work area should be considered a hazardous area into which
no-one should enter while the Multi-Tool is being used, and when necessary this area should be
marked with a warning rope, warning signs, or other forms of warning.
When work is to be performed simultaneously by two or more operators, care should also be
taken to constantly look around to check the presence and locations of other operators within the
work area to maintain a safe distance between each operator.
Before beginning work, each component of the Multi-Tool should be checked to make sure that it
is in proper working order, make sure that there are no loose screws or bolts, fuel leaks, ruptures,
dents, broken guards or any other problems which might interfere with safe operation.
Keep all parts of your body away from the cutting head when the engine is running.
Before Starting the Engine
Carefully check the work area to make sure that no obstacles exist within a perimeter of 15
metres around the Multi-Tool before starting the engine.
To start the engine, place the Multi-Tool onto the ground in a flat clear area and hold it firmly
in place to ensure that neither the cutting head nor the throttle come into contact with any
obstacles when the engine starts.
After starting the engine, make sure that the cutting head stops moving when the throttle trigger
is released (idle). If the cutting head continues to move when the engine is at idle, adjust the
idle screw on the carburettor to a point where the cutting head stops moving, if this cannot be
achieved, take the Multi-Tool to your authorised service dealer for adjustment.
Summary of Contents for 26MT-SP
Page 38: ...26MT SP Multi Tool 38 Original Instructions Version June 16 Parts Diagram Engine...
Page 42: ...26MT SP Multi Tool 42 Original Instructions Version June 16 Parts Diagram Body...
Page 46: ...26MT SP Multi Tool 46 Original Instructions Version June 16 Parts Diagram Hedgetrimmer...
Page 49: ...26MT SP Multi Tool 49 Original Instructions Version June 16 Parts Diagram Pole Pruner...