26MT-SP Multi-Tool
30
Original Instructions Version June 16
Allow the engine to warm up before use. When cutting, always use the Multi-Tool on full throttle.
NOTE
Avoid pulling the rope to its full travel or releasing the recoil handle when the recoil rope is
extended. Such actions can cause starter failure.
Hot Engine Starting
•
Set the ignition switch to the START ( I ) position (d,fig 3 page 29).
•
Check the clear return fuel line. If the line is empty, push the air purge bulb until fuel is
visible in the clear return fuel line.
•
Set the throttle to fast idle as in fig3 previously.
•
Pull the starter rope until the engine starts.
•
If the engine does not start after 5 pulls, use the Cold Start procedure.
Overchoking
Should the engine become flooded due to overchoking, turn the ignition switch off, unscrew the
spark plug, wipe it dry or replace.
Stopping the Engine
Set the engine to idling by releasing the throttle lever.
Set the ignition switch to the off position ‘’O’’ (STOP).
If the engine fails to stop, set the choke lever to the closed position to stall the engine; do not use
the machine until the ignition switch is repaired.
NOTE
Fig 6 - Pull the starter rope until the engine
starts, then squeeze the throttle briefly to
release the fast idle control and return the
engine to idle.
Fig 5 - Move the choke lever (C) to the
open (
) position.
(C)
Summary of Contents for 26MT-SP
Page 38: ...26MT SP Multi Tool 38 Original Instructions Version June 16 Parts Diagram Engine...
Page 42: ...26MT SP Multi Tool 42 Original Instructions Version June 16 Parts Diagram Body...
Page 46: ...26MT SP Multi Tool 46 Original Instructions Version June 16 Parts Diagram Hedgetrimmer...
Page 49: ...26MT SP Multi Tool 49 Original Instructions Version June 16 Parts Diagram Pole Pruner...
