![background image](http://html1.mh-extra.com/html/mitox/26mt-sp/26mt-sp_operators-manual_1807939024.webp)
26MT-SP Multi-Tool
24
Original Instructions Version June 16
Chain Oil
Filling the Oil Reservoir
• Fill the chain oil tank with low
viscosity chain oil or Mitox Chain Oil
this is availble online at www.mitox.co.uk
or at your local dealer.
• Do not use waste or regenerated oil that can cause damage to the oil pump.
• The oil reservoir has a capacity sufficient to provide about 20 minutes of cutting time (when set
to deliver the minimum flow rate). Be sure to refill the oil tank every time when refuelling the
saw.
Checking the Oil Supply
• After starting the engine, run the
chain at medium speed and see
if chain oil is thrown off as shown.
Adjusting the Oil Flow Rate
Never fill the oil reservoir or adjust the oiler with the engine running.
• An increase in bar oil flow rate will speed oil consumption, requiring more frequent checks on
the oil reservoir.
• The guide bar and chain are lubricated automatically by a pump that operates whenever
the chain rotates. The pump is set at the factory to deliver a minimum flow rate, but it can be
adjusted in the field. A temporary increase in oil flow is often desirable when cutting hardwood.
NOTE
Summary of Contents for 26MT-SP
Page 38: ...26MT SP Multi Tool 38 Original Instructions Version June 16 Parts Diagram Engine...
Page 42: ...26MT SP Multi Tool 42 Original Instructions Version June 16 Parts Diagram Body...
Page 46: ...26MT SP Multi Tool 46 Original Instructions Version June 16 Parts Diagram Hedgetrimmer...
Page 49: ...26MT SP Multi Tool 49 Original Instructions Version June 16 Parts Diagram Pole Pruner...