MiTAC A770, Operator'S Manual

Page: 56 / 107

Operation
2-9
2-3.7 Hard Disk Drive Module
To remove and replace the HDD module.
NOTE
Installing or removing a hard disk when the computer is “On”
can destroy the system board and hard disk.
1. Turn the A770 “Off”.
2. Loosen the captive screws securing the access door.
3. Use the handle on the access door to carefully pull the HDD module out
and away from the A770 (See Fig 2-8).
4. Insert the new Hard module into the slot. Gently push the HDD module in,
until it seats firmly in place. Secure the captive screws on the access door.
Turn the power back “On” to the A770.
Figure 2-7 Removing a PCMCIA Cards
PCMCIA Card