Mita DP-1400, Instruction Handbook Manual, Page: 96 / 134

5.4. Print Quality Problems
5-6
Clean the main charger wire.
Open the printer's side cover. Pull the green main charger wire cleaning knob slowly in and out a few times.
See Section
4.2 .
Check the main charger unit installation.
Open the printer's side cover. Remove the main charger unit half way out, then reinstall it properly. See sec-
tion
4.2 .
Call for the assistance of a service person.
If the above checks do not solve the problem, call for the assistance of a service person.
Dirt on the top edge or back of the paper
Check the paper chute and the ramp.
Draw out the paper feed unit and check for toner on the paper ramp. Clean the paper ramp (see Section 4.2 .)
using the wiper supplied, or a soft, dry, lint-free cloth.
Check the transfer roller.
If the transfer roller is dirty with toner, try printing several pages; or call for the assistance of a service person.
Characters out of position
Check the file or program.
See if the problem is caused by incorrect PRESCRIBE 2e commands. If the problem occurs with only one file
or program, the most likely cause is a command error.
Call for the assistance of a service person.
If the above checks do not solve the problem, call for the assistance of a service person.