Minuteman Continuous Power Series, Owner'S Manual

Page: 14 / 58

1 2
Figure 3-1. Attaching the Stabilizing Bracket to the UPS
C
ONNECTING THE
H
ARDWIRED
UPS
Hardwired units have input and output terminal blocks that connect directly to
the AC input source and load(s). The terminal blocks are located on the rear
panel, behind the rear panel plates as shown in Figure 3-2 and 3-3. This
section explains how to select the wiring, locate the terminal blocks, and
connect your loads and AC input.
Please note that the first boldfaced sentence of each step explains the step
briefly. The remaining text explains the step in greater detail.
Also note the following Pre-installation Considerations before beginning instal-
lation procedures.
PRE-INSTALLATION CONSIDERATIONS
W A R N I N G W A R N I N G W A R N I N G W A R N I N G W A R N I N G
ELECTRICAL SHOCK HAZARD. The hardwired models must be
installed by a qualified electrician or technician , or some other
qualified personnel. The UPS and batteries may contain HIGH
VOLTAGES. These high voltages can injure or kill personnel
and damage equipment.
N O N O N O N O N O T E T E T E T E T E
1. The UPS batteries are sealed, lead-acid, and mainte-
nance-free. These batteries are designed to give their
longest service when used in an ambient temperature
of 77°F (25 °C).
2. Operate the UPS in a protected environment within a
temperature range of 23°F to 104°F (0°C to 40°C) and a
relative humidity of 0-95%, without condensation.
Section 3 Installation
WARNING
NOTE