2 | minnkotamotors.com
©2019 Johnson Outdoors Marine Electronics, Inc.
Phillips
Screw
Phillips Screw
Phillips Screw
Spacers
Spacer
Spacer
Gas Spring
Cylinder
Gas Spring
Cylinder
Outer
Arm
Outer
Arm
Outer
Arm
Outer
Arm
Upper
Cylinder
Pin
d. Once the screws are removed, the pin and spacers
can be removed from the Upper Cylinder.
e. Now it is safe to remove the motor from the bow
mount when the motor is in the deployed position.
Gas Spring
Cylinder
Outer Arm
Outer Arm
b. To disconnect the Gas Spring, locate the Upper
Cylinder Pin. Two Phillips Screws hold the Upper
Cylinder for the Gas Spring in place. Using two #3
Phillips screwdrivers, hold the screw at one end of
the Upper Cylinder Pin in place.
c. Remove the screw at the opposite end of the pin
with the other #3 Phillips screwdriver.
WARNING
The gas assist lift mechanism in this unit is under high
spring pressure when the motor is in the deployed position.
Do not remove the Steering Module assembly from the mount
without disconnecting one end of the gas spring. Failure to
do this can create a condition where accidental pulling of
the pull grip and rope may cause the mount to spring open
rapidly, striking anyone or anything in the direct path.
NOTICE:
Use a #3 Philips screwdriver to remove the
screws. They have a pre-applied thread locker. Not using
the recommended tool can cause damage and prevent
them from being removed.
a. With the gas spring disconnected, place the motor
in the deployed position.
WARNING
Moving parts can cut or crush. The gas assist lift
mechanism is under pressure. Disconnect gas spring
before removing motor from mount. Do not engage the
pull grip and rope until gas spring is disconnected.
Remove Motor from Mount
2
3
1
