Page 5 of 50
AN-49-003 Rev.: E (September 6, 2019) M175867 (R95153) File: AN49003.doc
This document and its contents are the property of Mini-Circuits
1
Chapter 1
– General Information
1.1
Scope of the User Guide
This user guide provides general introduction, installation instructions and operating information for the Mini-
Circuits Synthesized Signal Generator series and its Graphical User Interface (GUI) application
measurement software.
1.2
Warranty
See Mini-Circuits website
http://www.minicircuits.com/support/ordering.html
1.3
Definitions
Note:
A note advises on important information you may need to ensure proper operation of the equipment. This
information does not indicate risk to either the equipment or the user.
A caution advises about a condition or procedure which can cause damage to the equipment
(no danger to users).
A warning alerts to a possible risk to the user and steps to avoid it. DO NOT
proceed until you
are sure you understand the warning.
1.4
General Safety Precautions
Please observe the following safety precautions at all times when using Mini-Circuits SSG
Synthesized Signal Generators.
Ensure that all instruments using mains power supply are properly grounded to prevent risk of
electrical shock.
1.
Use the power cord provided with the generator.
2.
Ensure the generator air vents are clear
3.
Do not provide inputs to the generator exceeding the limits specified in the datasheet
CAUTION
WARNING
WARNING
CAUTION
