Page 38 of 50
AN-49-003 Rev.: E (September 6, 2019) M175867 (R95153) File: AN49003.doc
This document and its contents are the property of Mini-Circuits
Figure 3.8.1
Multi Generator sweep
–Table of data points window
3.8.2
Bottom of screen
:
Run
– Clicking ‘Run’ after the table of frequency and power points was generated will start the sweep (See
).
Stop
– Clicking on this will stop the sequence.
Dwell Time (ms)
– Specifies (in milliseconds) the time the generators will hold each point before moving on
to the next point in the sweep. Minimum dwell time is 50 mSec.
Turn RF ON at Start
– Selecting this will ensure that all the generators selected will switch to
RF ON
at
start. If this option is not selected, you need to go to the main screen of each
generator to select
RF ON
before starting a sweep. While the sweep is running the
current output of each generator will be highlighted (see
).
Turn RF OFF at Stop
– Selecting this will ensure that all the generators selected will switch to
RF OFF
as
soon as the sweep is stopped. If this option is not selected, the generators will
continue outputting the last signal when you click on
‘Stop,’
or the sweep ends.
