MP 26/10
Installation and Calibration Manual
Minebea Intec
EN-10
3.
Operation
3.1.
Power ON
After Switching ON the supply the device gets powered up, the device initializes itself
(display, load cell lines) & check for any errors. The status of the device is given by the LED
(Red / Green). For proper operation the system should be warmed up for minimum 20
minutes.
The initialization also takes place when loading the configuration through serial port
from the MP26/10 software
3.2.
Status LED
The status LEDs indicates the status of the device. The status is given by the color of the lit
Green indicates normal operation
Red indicates limit value1 is in active/ON state
Red blinking indicates instrument fault, configuration mistake
3.3.
Display
There are two display lines available in the device. The first line displays the process values.
The second line displays the unit/error list /Configuration settings / parameters.
Default display mode
Display of further operating levels
There are two modes of display available in the device based on the level in which the user is
working.
Default display mode:
This shows the processed weight value along with its unit.
Operating mode:
This mode enables us to set the configuration or parameter or display error
or to calibrate the system
Note
With faulty input values, signals dependent on the inputs (e.g. Inp1, Inp2, display value, Out3) also indicate FAIL.
