Minebea Intec CAW3P, Operating Instructions Manual

Page: 92 / 188

SQmin Operation
Configuration in Service Mode The SQmin value can only be entered in Service mode.
t
Remove the cap.
t
Slide the menu access switch to the left (= “open“ position).
If the device is part of a verified weighing facility, this will only be possible if the
verification seal is broken. The weighing equipment must then be verified again.
t
Activate the Service mode, see “Service Mode.“
t
In the “
Device parameters
“ menu, select “
SQmin
“ and open
using the “
O
“ soft key.
t
Select “
SQmin input
“ using the “
O
“ soft key.
t
Select “
SQmin WP1
“ using the “
O
“ soft key, enter the value via the keypad
(in this example 0.100 kg) and save using the “
l
“ soft key or cancel using “
ESC
.“
t
Then enter the values for WP 2 and WP 3.
t
Press
M
or “
oo
“ to exit the Setup menu.
t
Slide the menu access switch to the right (= “closed“ position) and reattach the
cap.
y
The device is now in normal weighing mode.
Configuration in Weighing Mode
t
In the “
Device parameters
“ menu, select “
SQmin
“ and open
using the “
O
“ soft key.
t
Select “
Display
.“.
t
Open using the “
O
“ soft key.
t
Confirm the factory setting “
oYes
“ using the “
l
“ soft key.
t
Press the “
o
“ soft key several times to switch to the next highest menu.
The SQmin display must be turned on to use the SQmin function.
t
In the “
Fn key:SQmin display:
“ menu, select using the “
O
“ soft
key and confirm using the “
l
“ soft key.
t
Press
M
or “
oo
“ to exit the Setup menu.
92 Operating Instructions Combics Complete Scales
Operation