Minebea Intec CAW3P, Operating Instructions Manual

Page: 38 / 188

Function Allocation of the allocation
for the J Key for Calibration/Adjustment
Purpose The
J
key is used for the calibration/adjustment function. Key settings can be
changed when the Service mode is activated:
Procedure
t
Remove the cap.
t
Slide the menu access switch to the left (= “open“ position).
t
Activate the Service mode, see “Service Mode.“
t
Select weighing platform “
WP 1
“ in the “
Device Parameters
“
menu item.
t
If the “
Internal
“ setting is not already activated (marked by “
o
“), select
the setting using the “
Q
“ or “
q
“ soft key and confirm with “
O
.“
y
The menu for the “
WP-1 INTERNAL
“ device parameters is displayed.
t
Use the “
Q
“ or “
q
“ soft key to select and open the “
Calibration/
adjustment
“ menu using “
O
.“
t
Use the “
O
“ soft key to open the “
Cal/adj. sequence
“ menu.
t
Use the “
Q
“ or “
q
“ soft key to select the “
Cal. then manual
adj.
“ menu (factory setting) and confirm with the “
l
“ soft key.
t
Use the “
o
“ soft key to go to the next menu level.
t
Use the “
O
“ soft key to open the “
Activate ext. adj.
“ menu.
t
Use the “ Q “ or “ q “ soft key to select the “
Activated
“ menu item
(factory setting). Not for a verifiable configuration.
t
Geographical data is not displayed during calibration/adjustment (factory
setting).
To display geographical data in the Device parameters menu, open the
“
Operating parameters
“ submenu.
Menu item “
Display geogr. data
>
On
“.
38 Operating Instructions Combics Complete Scales
Configuring Weighing Platforms