Minebea Intec CAW3P, Operating Instructions Manual

Page: 34 / 188

Entering Gravity
t
Use the “
Q
“ or “
q
“ soft key to select the corresponding input field.
t
Enter gravity in m/s 2 via the keypad and confirm using the “
l
“ soft key.
Permissible value range:
9.700000
d < gravity 2 d <
9.900000
In the example shown here, the value for gravity has been changed.
The new value,
9.810000
m/s2 applies to the setting “Germany (Zone D).”
t
Press the “
o
“ soft key to exit the Input menu.
t
Use the “
Q
“ soft key to select the “
Save parameters
“ menu item.
t
Use the “
Q
“ soft key to select “
Yes
“ and use the “
l
“ soft key to confirm.
y
The message “
Data stored
“ appears briefly.
The program then returns to the “
No
“ display status.
t
Press
M
or “
oo
“ to exit the Setup menu.
t
Slide the menu access switch to the right (= “closed“ position) and reattach the
cap.
y
The display goes out and the device restarts. Then weighing mode is active.
Adjusting Scales in Operating Mode
See also “Calibration and Adjustment“ in the chapter called “Operation“
t
Open the Device parameters menu for the respective weighing platform,
(e.g. “
WP 1:INTERNAL
“).
– Open the “
Calibration/adjustment
“ submenu.
– „
CAL key function
“ menu item:
Setting “
Ext. cal./adj.: factory-def. wt.
“
(factory setting).
– „
Cal/adj. sequence
“ menu item:
Setting “
Cal. then manual adj.
“ (factory setting).
– „
Activate ext. adj.
“ menu item
(not for a verifiable configuration):
Setting “
Activated
“ (factory setting).
To display geographical data in the Device parameters menu, open the
“
Operating parameters
“ submenu.
Menu item “
Display geogr. data
>
On
“.
t
Press
(
to unload the scale.
34 Operating Instructions Combics Complete Scales
Configuring Weighing Platforms