NetGuard Service Manual
0070-10-0685
2 - 11
Repair Information
Troubleshooting
2.2.4
Telnet Instruction
Telnet to the access point to verify the correct IP address, subnet mask, channel, and software
revision before you program.
1.
Verify the access point is connected to the PoE Switch or PC you are programming from.
2.
If connected to the PC, connect the PoE Injector to the access point.
3.
Go to the
Start
button, select
Run
, and enter
cmd.
FIGURE 2-7
4.
Select
OK
.The Windows\system 32\.cmd.exe window (shown in FIGURE 2-8 )
appears.
5.
After the “>” prompt, enter the word
telnet
followed by the IP address, then press
Enter
.
NOTE:
Be sure to have a space between “telnet” and the “IP
address”. For example: telnet 192.168.1.2.
NOTE:
Do not type the command telnet and select Enter. This will
bring you to the telnet function which will not allow
programming. To exit the telnet function, type exit.
FIGURE 2-8
The Telnet window (shown in FIGURE 2-9) opens as Telnet 192.168.1.2 (or whichever IP
address was entered). The information listed is everything needed to know about the access
point.
Summary of Contents for NetGuard
Page 1: ... Datascope NetGuard Service Manual 0070 01 0685 01_revB indd 1 3 10 10 5 23 19 PM ...
Page 2: ... Datascope NetGuard Service Manual ...
Page 5: ...Table of Contents ii 0070 10 0685 NetGuard Service Manual ...
Page 9: ...vi 0070 10 0685 NetGuard Service Manual This page intentionally left blank ...
