Troubleshooting
Repair Information
2 - 6
0070-10-0685
NetGuard Service Manual
NOTE:
If software is being loaded for the first time, leave "Create
Database" checked. If updating the software to a new
revision, uncheck "Create Database".
e.
When the installer finishes, select the option
Yes, I want to restart my
computer now.
f.
Enter a reason for the shut down.
NOTE:
The system will not shut down until a reason is entered.
g.
After the reboot, close the Manage Your Server dialog, if it displays.
4.
After the server installation, connect the CAT5e patch cable between the server and the
switch.
5.
Verify the LED on the switch illuminates/flashes for that port.
6.
Telnet to each access point and set/verify the following:
• Firmware revision is correct
• MAC address matches the documentation
• IP address
• Subnet mask
NOTE:
Remain in Telnet to change any of the parameters. Refer to
the Telnet section of this manual.
7.
Enter the Configuration files on the server by navigating to the following:
C:\Program Files\Datascope Corp\WDRS\WDRS.exe.config
a.
Verify the Alarm Delay is set at 15. If not, delete the number listed and enter 15.
b.
Save the file.
Connect your PC to the network switch (change PC IP address to match the server IP address
scheme) and ping the server IP address.
Summary of Contents for NetGuard
Page 1: ... Datascope NetGuard Service Manual 0070 01 0685 01_revB indd 1 3 10 10 5 23 19 PM ...
Page 2: ... Datascope NetGuard Service Manual ...
Page 5: ...Table of Contents ii 0070 10 0685 NetGuard Service Manual ...
Page 9: ...vi 0070 10 0685 NetGuard Service Manual This page intentionally left blank ...
