– 3.38 –
Detect procedure ( [DIST.REVI.] Setting value is "AFTER")
1) Perform the procedure "Detect procedure
([DIST.REVI.] Setting value is "BEFOR")" of
step1 to step3. (
Page 3.36)
2) Press the [ENTER / HOLD] key.
•
In case [ROLL. SELECT] is set [ON], select the
number of pinch roller to use. (
Page 2.16)
Start the registration mark detection after detecting only the
sheet width.
If any of the marks cannot be detected, the message shown
on the below will appear on the LCD. In this case, set the
sheet properly.
•
For details on numbers of the detected registra-
tion marks, refer to the Page 3.33.
*
Sheet set should set to rear.
3) After detecting the registration marks, the
scale correction display appears. (The right
sample shows the 4 points detection display.)
In case the actual measured value and the detected lengths
differ, set the value with the jog keys [
] [
].
Push on the [ENTER/HOLD] key to the following scale
correction setting.
•
If [DIST. REVI.] is set to [OFF], the display will
not appear.
•
If [MARK DETECT] its set to [2ptA], the display
to enter the B length will not appear.
•
If [MARK DETECT] is set to [1pt], the scale
correction setting display will not appear but the
origin point.
6) Push on the [ENTER/HOLD] key after complet-
ing the settings.
Set the origin.
After detecting the registration marks, the appropriate cutting
area will be displayed, then local mode will return.
ERROR36 MARKdetect
CT1 020 050 0.30
**
ORIGIN
**
ROLL < R > LEAF
**
MARK DETECT
**
A (1-2) =
***
.
*
B (1-3) =
***
.
*
A (3-4) =
***
.
*
A =
****
B =
****
Summary of Contents for CG-FX SERIES
