MIMAKI CG-FX SERIES, Operation Manual

Page: 64 / 142

– 3.12 –
Feed the paper [FEED]
The sheet is fed by the length to be used.
In the case where a roll sheet is used or a long-dimension data is to be cut (plotted), the sheet has to
be fed by the length to be used to provide an allowance. In addition, displacement of the sheet can
be checked by feeding the sheet.
Setting value
For “mm”: 0.1 m to 51.0 m (in increments of 0.1 m)
For “inch”: 1 to 167 feet (in increments of 1 ft.)
1) Push on the [FEED] key in a local mode.
2) Press the jog key [ ] [ ] to set the feed
amount.
3) Push on the [ENTER/HOLD] key.
The sheet is fed from the origin.
In case the sheet length is shorter than the set value, sheet feeding stops as displaying the fed sheet
length.
If this display appears on the LCD, press any key to reset it.
• To interrupt the sheet feed, press the [END] key.
Clear the data [DATA CLEAR]
Clear the data to interrupt the data cutting (plotting).
In case data not cleared, the received data will be cut when returning to the remote mode.
• After the execution of data clearance, the received data will remain in the
receiver buffer. It is, therefore, possible to cut (plot) the data in repetition
using the plural sheet cutting function.
* Do not execute the data clear function during data sending.
Execute data clear before receive a data in a remote mode to cut (plot) a new data.
**
STOP : 0.3m
**
DATA CLEAR <ENT>
SHEET FEED: 1.0m
SHEET FEED: 10.0m
SHEET FEED: 8.0m