MIMAKI CG-FX SERIES, Operation Manual

Page: 24 / 142

– 1.8 –
Carriage
Pen-shaped cutter and tool holder are attached to the carriage. Sensor for detecting a sheet / registra-
tion mark, and sheet cutter are also attached.
Light pointer lights up in red during positioning for the registration mark detection.
When the registration mark detection is set to non-OFF, the light pointer goes out by pushing over
the clamp lever. Pull the lever forward to light up the light pointer.
Make sure if no action performed for five minutes after pulling clamp lever down, the light pointer
will automatically go out.
Pinch rollers and grit rollers
The portion located between the pinch rollers 1 and 2 is the travel range of the carriage. Move the
pinch rollers to appropriate grit rollers in accordance with the width of sheet to be loaded on the
device. The areas within which the pinch rollers may be shifted are described below. Change the
location of the pinch rollers using the “PINCH ROLLERS SETTINGS” marks as a guide.
Pinch roller 1
"PINCH ROLLER SETTINGS" mark
Pinch roller 2
* Be sure to raise the pinch rollers whenever the machine is not in operation.
* Keep away from the rotating grit rollers. Injury could result if the rotating grit
rollers are contacted since the rotating grit rollers can shave the skin or the
rotating grit rollers and platen can catch fingers between them.
* Never set the pinch rollers with deviated or separated from the grit rollers. In
case the pinch rollers not set properly, it may cause an error and the sheet
detect cannot be performed correctly.
Pinch roller
Grit roller
Sensor
Blade for sheet cutter
Tool holder
“PINCH ROLLERS SETTINGS” marks
White mark
Light pointer