– 2.16 –
Loading a leaf sheet
1) Pass a leaf sheet under the platen.
Tilt the set lever toward you, raise the pinch rollers and adjust
the rightmost end of the leaf of sheet to the lib of the platen.
Alternatively, align the sheet front parallel to the platen.
2) Move the pinch rollers according to the sheet
width.
Refer to page 1.9 for the pinch rollers.
*
Change the location of the pinch rollers so that
each one is placed 5 mm or more inside the
sheet width. If not, the sheet can slip off the
pinch rollers while it is being fed.
3) Tilt the clamp lever away from you and lower
the pinch rollers.
The display shown on the display panel will change as
illustrated below.
4) Press the jog key [ ] or [ ] to select
“LEAF”.
[ ] : In the case where the media is loaded from the rear
[
] : In the case where the media is loaded from the front
5) In case [ROLL. SELECT] is set [ON], select the
number of pinch roller to use.
Press the jogkey [ ] or [
] to select.
6) Press the [ENTER/HOLD] key
The device performs the sheet detection (see page 2.14),
then performs a dummy cutting (see page 3.45).
*
The device is not able to detect a leaf sheet of
which length is 3 m or more.
ROLL F LEAF
Displays the detected size of the leaf sheet.
<
<
Unit: mm
Displays the currently specified tool
conditions.
CT1 020 050 0.30
A=654 B=459
ROLL < R > LEAF
PINCH ROLL . : 3
Summary of Contents for CG-FX SERIES
