MIMAKI CG-FX SERIES, Operation Manual

Page: 122 / 142

– 4.4 –
Trouble for which error messages are given on the LCD
Error message
Error messages shows as the error numbers.
Take an appropriate corrective measure according to the remedies given in the table below.
ERR02 MAIN RAM Trouble has occurred in the
control RAM.
Please call your dealer or our
company’s sales office for service.
ERR04 EEPROM Trouble has occurred in the
system ROM.
ERR10 COMMAND Code other than command data
have been received.
Check up the command data sent
from the host computer.
ERR11 PARAMETER A parameter outside the numeri-
cal limits has been received.
Check up the parameter.
ERR13 PM OVER Data on polygon has overflown
the polygon buffer.
Divide the data on polygon.
ERR15 AUTO FEED The device has failed to feed the
sheet by the length specified with
ZX command.
After the receipt of data sent from the
host computer, replace the sheet with
a longer-dimension one and execute
the plural sheets cutting.
During division cut, the device has
failed to feed the sheet, according
to the second data, by the length
specified by the first data.
Load a longer sheet on the device and
re-set the device in the remote mode.
Error message Cause Remedy
ERR06 BUFFER Trouble has occurred in the
receiver buffer.
ERR08 POWER Trouble related to the motor has
occurred.
ERR12 DEVICE The device received an im-
proper device control command.
Check up the device control com-
mand.
ERR20 I/O Communication conditions are
wrong.
Establish the same communication
conditions with those established
on the host computer.
ERR27 BUFFERover The interface is faulty.
Establish the same communication
conditions with those established
on the host computer or check up
the interface cable.
ERR30 OPERATION
An inappropriate operation was
performed on the control panel.
Perform the correct operation.
ERR16 AUTO I/F The device has failed to detect a
command automatically.
Set the command name.
ERR31 NO DATA The device has executed the plural
sheets cutting to find that there is
no data in the receiver buffer.
Refer to the explanation of the
plural sheets cutting function. (See
page 3.16)