3-51
3
Use
ful Func
tion
Make the media without uncut area
By over wrapping the start point and the end point arbitrarily, you can
make the media without uncut area.
Specify the over cut function (valid/invalid) and the length of the over
cut.
If the length of the over cut is set, when cut starts, cut will be
performed from the position to the front by the specified length and the
tool will move up going too far at the end.
1
Press the
key in the local
mode.
2
Press the jog key
or
to select
[SET UP] .
3
Press the
key.
4
Press the jog key
or
to select
[OVER CUT] .
5
Press the
key.
6
Press the jog key
or
to select
OVER CUT setting.
•
Set values
: OFF or a value from 0.1 to 1.0mm (0.1mm unit)
7
Press the
key.
8
Press the
key twice for terminat-
ing this function.
• Setting proper over cut can reduce uncut area of start and end point of a media easy to bend.
If too large value is set, the result may have a rupture
Over cut
part
D A T A
C L E A R
< E N T >
FUNCTION
S E T
U P
< E N T >
ENTER/HOLD
O V E R
C U T
< e n t >
O V E R
C U T
:
O F F
ENTER/HOLD
O V E R
C U T
: 0 . 3 mm
0.1 to 1mm
0.1 to 1mm
ENTER/HOLD
END
Summary of Contents for CG-60SR
