3-69
Miscellaneous Settings
3
Use
ful Func
tion
Dummy Cutting
The plotter executes dummy cutting in front of the pinch roller that
is located on the side closer to the current location of the carriage.
Set the dummy cut function to OFF if you do not want to dummy-cut
the sheet that is to be used with characters cut out.
Sheet Setting
Do not cut (plot) a heavy or wide sheet at a high speed; otherwise the sheet may deviate.
Cutting (plotting) a heavy or wide sheet at a high speed may also result in the [ERR41 MOTOR B] error.
In such a case, select [HEAVY] in the sheet setting.
Compensated Pressure Offset
Some part of the sheet remains uncut if the pressure to bring the cutter blade down into the sheet is too low.
Some part around a corner of 120 degrees or less may remain uncut when an eccentric blade (available as
an option) is used.
This problem can occur because of such an intended operation that the cutting pressure automatically
drops (to approximately 5 g) around a corner to prevent the sheet from rising.
Some part may remain uncut if the cutting pressure is too low for the cutter blade to turn in the designed
direction smoothly. In such a case, make setting to raise the cutting pressure for smooth cutting around
corners.
• The default setting of the dummy cut function is ON.
If you set the dummy cut function to OFF, execute test cutting to adjust the cutter blade
orientation prior to cutting. (
P.2-20
)
Pinch Roller
Dummy cutting
Summary of Contents for CG-60SR
