MIMAKI CG-60SR, Operation Manual

Page: 115 / 144

3-67
Miscellaneous Settings
3
Use
ful Func
tion
Step Size
Some applications (especially the old ones) output only data with different unit from the basic resolution. In
such a case, you can change the setting value of this plotter to allow cutting in correct size.
Cutting Mode
Select “QUALITY” in any of the following cases:
• Characters whose sizes are 10 mm or less are to be cut
• Picture patterns or characters that have many sharp corners are to be cut
• Minute cutting is to be performed
However, the edges of finished patterns may be rugged if the data sent from the host computer is too
complicated. In such a case, select “HIGHspd” for smooth finish.
Origin Switching
When the ROTATION function is ON, the origin is as follows:
• Setting the command origin point to the [LOWERrightORIGIN] will expand the cutting area up
to 51 m.
• The cutting area is 3 m if the command origin is set to [CENTER ORIGIN].
Rotation : OFF
Rotation : ON
LOWER right ORIGIN CENTER ORIGIN
Command origin
LOWER right ORIGIN CENTER ORIGIN