Change the cutting (plotting) order
3-50
Sorting sequence
1
Data transmission is started.
• The size of unprocessed data in the receiver buffer is displayed.
• Cutting is not performed. The processed line segments are stored in the sorting buffer.
2
After completion of data transmission,
the display shows the waiting time for
the start of cutting.
• Remaining time is displayed in seconds.
• If no data is received during waiting for the start of cutting, the counter continues counting
down.
3
Auto-feed is executed.
• Before starting cutting, the plotter feeds out the sheet by the length equivalent to the
cutting data. If the sheet is not long enough to cover the cutting data, the error shown
below is displayed.
• After replacing the sheet with a long sheet, perform data transmission or execute
[No.COPIES]. (
P.3-10
)
4
Cutting starts.
• The data percentage for which cutting has been
already performed is displayed.
5
Cutting is completed.
• The plotter returns to remote mode.
• When SORTING is set to ON, the plotter will not start cutting until the specified close time
elapses after receiving all pieces of cutting data.
In the following cases, however, the received pieces of data are sorted and cutting is started
before the lapse of the close time.
a ) The sorting buffer is full of data.(Approximately 540,000 line segments.)
b ) The Tool number, SPEED, PRESSURE or any other cutting condition has been changed.
c ) The feed command or origin change command is executed.
C U T 1
*
2 K B
*
* *
P L O T
* *
5 S
* S O R T I N G *
1 %
E R R 1 5
A U T O F E E D
* S O R T I N G *
1 0 0 %
C U T 1
*
R E M O T E
*
Summary of Contents for CG-60SR
