3-65
Miscellaneous Settings
3
Use
ful Func
tion
Setting List
Function
name
Outline
Setting values
Command
Switching
Switch the unit of moving amount
specified by a command.
AUTO
This is to automatically switch the command
according to the command specifications of
the receiving data.
MGL-IIc
This is selected when the plotter receives the
data of MGL-IIc command.
MGL-Ic1
This is selected when the plotter receives the
data of MGL-Ic1 command.
Step size
Switch the unit of moving amount
specified by a command.
AUTO
When the command switching is set to
“AUTO,” this step size is 0.025mm for the
received command of MGL-IIc, and 0.05mm
for that of MGL-Ic1.
MGL-IIc
When the command switching is set to “MGL-
IIc,” either one of 0.025mm or 0.01mm is
selected for this step size.
MGL-Ic1
When the command switching is set to “MGL-
Ic1,” either one of 0.025mm, 0.05mm or
0.1mm is selected for this step size.
Cutting
Mode
This is to set the cutting quality.
Standard
This is a regular cutting mode.
High speed
This is used to perform cutting in a short time
(it is not appropriate for the heavy sheet).
High quality
This is a cutting mode used to give priority to
cutting quality.
Origin
Switching
At the time of MGL-IIc command,
this function sets the position of
command origin.
(At the time of MGL-Ic1 command,
the command origin is positioned in
the lower right.)
Center
This is to set the command origin in the
center of effective cutting area.
Lower right
This is to set the command origin in the lower
right of effective cutting area.
Buzzer
With this you can control the key-
pressing sound and the alert sound
caused at the time of error
occurrence.
ON
This is for making the buzzer sound.
OFF
This is not to make the buzzer sound
(also make no confirmation response sound
of registration mark sensor).
Priority
When this plotter and the host
computer make different settings on
a same item, this function is used to
set about which of the two must be
given priority to (This is only for
MGL-IIc).
Host
This is to give priority to the setting of host
computer.
Panel
This is to give priority to the setting of this
plotter.
Size
Response
Value
This is used to set the largest
response value of effective area
read command from the host
computer (This is only for MGL-Ic1).
1 to 51m
Sheet
Sensor
This is to detect the sheet existence
and the sheet length.
ON
This is to detect them.
OFF
This is not to detect them.
Up Speed
This is to set the speed of sheet and
carriage movement when the tool is
up.
Setting the speed lower makes the
sheet misalignment reduced at the
time of long sheet feeding.
5,10,20,30,4
0,50,60,
AUTO
(cm/s)
When setting to AUTO, the speed value set in
the TOOL conditions is used as the up-speed
(but the lowest speed is 10cm/s).
Summary of Contents for CG-60SR
